If you disconnect the battery you … will need to do it again. Personally I think it is an individuals choice to wear or not wear the seatbelt. Find or make a spare seat belt buckle and plug it in. Turn the ignition back off. You need to remove the four bolts holding the seat in place togain easy access to the seatbelt female side.
It only requires the use of a 14mm wrench. Worse, it could also cause your airbag to fire unexpectedly sounds hilarious, but could result in serious injury. Is that vehicle a manual or automatic transmission? It operates by magnet crazy, I know. You can look for one at a scrap yard or parts store. That's how I stopped mine from beeping.
It comes off easily with twosmall screwdrivers. It says in the manual that in order to turn off the seatbelt chime, it must be done at the dealership. Why is it such an issue? But I like to be able to sit in my car with it off without the damn car beeping at me. Try adding something heavy to the seat, then starting the truck up. Once you join you'll be able to post messages, upload pictures of your truck, and have a great time with other Toyota Tacoma fans.
My answer doesn't put the driver at risk, even if on private land, because the seatbelt can be used without rigging a buckle end up. Turn the key back to on. Then I pointed out to him that the flight of steps into the office was a total of about 5 feet in elevation and there was no railing, thus no 3 points of contact, and he didn't know what to say. The two black ones go to a connecter which I pulled apart and inserted a short jumper wire which stopped the constant, extremely annoying alam when the key is inserted and seat belt not yet buckled. Remove the small spring that pushed the inner switch assembly up when it's unbuckled. This brings me to your other point, about going 5mph. Some vehicles may have to go to the dealer to be reprogrammed with specific software.
This is only an example and not the actual disabling sequence for anything. It certainly doesn't render the belts ineffective at any other time, as you'd remove the spare tongue and use the belt properly. It does this about every 1500 miles. This usually consists of doing a series of tasks in the car while parked. It sucked and you could do the dance, the problem was you were in a different car every night and by the time you got them all turned off, they were serviced and would all be back on again.
Most newer vehicles are equipped with seatbelt warning chimes. I have a 2010 Toyota Camry. You might have to touch up the edges a bit but it works like a hot dam. Put your seatbelt connecter plastic on and bolt the seat in place. Toyota Motor Corporation, Toyota Motor Sales, U. I have to stop the truck and turn the key off to let it reset itself. Be sure that your airbags will not be affected before altering your seat belt alarm sensor.
Disabling the alarm is not illegal, in fact, the instructions can be found in your owner's manual. Any 3rd year law student would have an easy time of tying the seat belt mod to the malfunction. Not wearing one is stupid, and anyone who is looking for a way to deceive the system so that they can drive around without their seat belt on is a moron. I took my taco in for its first oil change the other day. Remove the switch from the seatbelt connecter there are two small tabs holding it in. While it was there I told them I wanted to turn off the seat belt buzzer. Which makes me think, if you disconnect those, you may disable the airbag that's in the outer side bolster of the backrest.
I agree that seatbelts save lives and I don't advocate driving without them, but there are times when that rapid ding gets to be more than a little annoying. Now put the seat back down, and retighten all of the bolts. My dealer disabled it without complaint. There are four wires under the seat on my 2015. Where does that leave us? In our minds, no where.