If the lever is pulled while in the. Keep this in mind when checking tire pressure inside a garage especially in the winter. Apply downward pressure on the top corner of the rear soft top bow 3—bow , then complete attaching the sail panel retainers into the body side channel. Some of the worst injuries happen when people are thrown from the vehicle. Inspect the brake linings, replace if necessary.
Loosely install the rear knob long knob to hold the sport bar and press onto the side bar making sure not to door rail in position. To install the side windows, affix the window tem- side channel, leaving the last 3 in 7. Raising the vehicle higher than necessary can make the vehicle less stable and cause an accident. Unclip and move the sun visors to the side. A belt that is buckled into the wrong buckle will not protect you properly. Turn the steering wheel back to center.
Oxygen- ates are required in some areas of the country during the winter months to reduce carbon monoxide emissions. Properly blended reformulated gasoline will pro- vide excellent performance and durability for the engine and fuel system components. If necessary repeat this procedure. They contain carbon monoxide, a colorless and odorless gas which can kill. The latest age group appearance quite similar to the previous era, which ended with the 2006 model year.
Release the header latches and leave the hooks in the loops on the windshield. Tire chains may be installed on all models except the Sahara and Rubicon. If you are looking for a tough long lasting vehicle, this this vehicle is a great option for you. This is accom- When operating your vehicle in 4L, the engine speed will plished by simply moving the shift lever to one of these be approximately three times four times for Rubicon positions. Also, be sure that the front seats are fully upright and positioned forward. Unfold door frame and unscrew thumbscrews. It warns other drivers to steer clear of you and your vehicle.
Finally, make sure that the check strap 8. Make room for more passengers, carry extra luggage or your favorite sports gear with the roof rack on the vehicle. This procedure consists of programming a Replacement Keys blank key to the vehicle electronics. Release the header latches and leave the hooks in the 6. Remove the brackets using a T30 Torx head driver. Secure the top by using the two provided straps.
No belt tension adjustments are required. Refer to the Maintenance Schedule in Section 8 for recommended engine air cleaner filter change intervals. Body Lubrication Locks and all body pivot points, including such items as seat tracks, doors, tailgate and hood hinges, should be lubricated periodically to assure quiet, easy operation and to protect against rust and wear. The following maintenance recommendations will enable you to obtain maximum benefit from the corrosion resistance built into your vehicle. Significant over or under-inflation of tires, or mixing sizes of tires or wheels on the vehicle can lead to loss of braking effectiveness. The windshield also provides some protection against weather, road debris and intrusion of small branches and other objects. When you encounter slick or muddy roads, you can engage the four wheel drive on this Jeep Wrangler Unlimited and drive with confidence.
When this feature is on, a check mark will appear in displayed. Can you safely recover the vehicle if something goes wrong? With the door open, lift the door to clear hinge pins from their hinges, and remove door. Identification Symbol This symbol means that the oil has Overfilling or underfilling the crankcase will cause been certified by the American aeration or loss of oil pressure. Remove the swing gate bar by pulling it straight rearward out of the swing gate brackets. Set the temperature exactly where you are most comfortable in the vehicle. Never attempt to straddle a rock that is large enough to strike your axles or undercarriage. Oil contamination will severely shorten bulb life.
Allow engine braking to control the descent and apply your brakes if necessary, but do not allow the tires to lock. A clutch within the torque converter engages automatically at calibrated speeds. Turn the steering wheel back to center. Insert the retainer along the bottom edge of the 18. This gear position supplements the parking brake by locking the transmission.
With the door open, lift the door to clear hinge pins 4. Enter the vehicle, and move the material into two folds. A slight speed change on moderate hills is normal. Then, clip the front of the door rail over the side bar making sure that the material for the side bar cover is not pinched by the door frame. An incorrectly anchored tether strap could lead to increased head motion and possible injury to the child. Seat Belt Indicator Light A warning chime and an indicator light will alert you to buckle the seat belts. Locate the wiring harness on the left rear inside corner of the vehicle.
If the soft top has been removed, follow these steps to reinstall the soft top. It provides a full year of coverage to protect you from major title problems that are missed from the Department of Motor Vehicles. For the outboard seating positions, route the tether under the head rest, and attach the hook to the tether anchor located on the back of the seat. Push downward on the handle to lower the seat. Undo the Velcro that runs along the top and rear corner of the window.