How do you reset oil service light Chevrolet Cobalt. After a day or so of looking at my car he told me I need a new computer. The shifting has made it difficult to drive and has almost caused me to be in accidents. It's great to have a well functioning car again! I called the dealership and they said they had to reset it to work with my car, but they are the liars that ruined it in the first place and sold me a bad car so I am looking for a neutral party to answer. If dash lights start blinking then press the brake one, … two or three times then turn the key back to off and turn back to the position before start.
Good luck and hope this helps. The light does go off when I turn my car off. The failure mileage was 80,681. I made mine out of that glade oil cap. I thought that the recall repair would fix the issue as I had it repaired a week ago. Dec 11, 2010 For a 2005 trailblazer to reset the oil change light you will need to make sure all doors are closed then turn key on and slowly push gas pedal to floor three times within five seconds, this must be done within 5 sec, from the time you turn key on, the key must be on so all dash light are on its right before the engine start postion, after you push gas pedal to floor three times the light will flash a few times then go out. Posted on Feb 25, 2009 After changing the oil and filter, reset the monitor by proceeding as follows: Turn ignition On, but do not start engine.
The light does go off when I turn my car off. The manufacturer was notified of the failure. A check engine light can indicate a broad spectrum of problems with your 2006 Chevrolet Cobalt. Prior to the incident, the traction control and check engine lights illuminated. For example, does it happen when you accelerating, driving on the highway or does it appear at low speeds? This won't stop your vehicle from hesitating and almost dying at stops. I went to go get my car recalled for power steering, and they said it's only for 2004 Cobalt models. After the repair the power steering light came on and the car became hard to steer.
Because I am getting completeness scenarios. Ps the new ecu I just bought is under warrantee for 12 months, they are currently putting the 2nd new one in today, I just figure it will go bad in a couple of weeks, like the first one. This interval is based on engine revolutions and temperature - not on actual mileage. A recall needs to be issued. The last time it happened while I was driving 70 down the interstate and I almost crashed into the divider wall trying to pull over. I have taken it twice to chevy dealer and they replaced some sensors but it did not work.
Oxygen sensor went bad, a cracked house and that sort of thing. Engine light comes on without any warning and the dashboard alert engine power reduced. Posted on Feb 25, 2009 After changing the oil and filter, reset the monitor by proceeding as follows: Turn ignition On, but do not start engine. When it has been turned off the traction control light doesn't come until driving again for about 5 minutes. Loose your tank straps, and lower the tank.
Thanks, Wes turn the key to on position, dont start it, then press the gas pedel three times with in seconds,turn the car to off position. Good luck and hope this helps. The failure mileage was 134,000. Traction control light comes on. It isn't very agile and the steering is too light at low speeds.
It seems to reset after the car is turned off for a while but if it happens it could cause serious crashes. If the diagnostics showed my work caused the problem, I wouldn't charge the diagnostics. When the traction light comes on the car begins to shift ruff, but this is not all the time. The engine oil life monitor is now reset. Could find no code in the system so they asked to keep the car for another day to run it. This occurs when the dealer is not a registered dealer or has not reset your meter.
The car gets very jerky and hard to drive. I know a lot of shops charge around 100 bucks or more for diagnostics, even if they don't fix the problem. The main thing that you should do is to do a maintenance on it. If you are unsure about what your diagnostic trouble codes mean; have your Cobalt diagnosed by a professional automotive technician. The Chevrolet Cobalt was an improvement over the dated, outgoing Cavalier, but it's still just an average small sedan.
This car operates on electric power steering system, has a wheelbase of 103. If the light comes back on for more than 5 seconds, repeat the procedure. I don't find that fair if so many people are having problems with the rest of their Cobalts. I went to go get my car recalled for power steering, and they said it's only for 2004 Cobalt models. Now it was beginning to become a safety issue! That it is the full procedure how to If you like to reset any maintenance oil light after an oil change. Usually the only way to clear codes is by getting the auto parts store, or dealer to clear them.
My speedometer and rmps go nuts. Press button with the gas pump symbol to display engine oil life. Take out the motor mount, replace the four spark plugs to a. Chevrolet Cobalt marketed as both a coupe and sedan, and is also sold in a Model of super high-performance sports car. Start with replacing the battery, if the money is tight do what i do and go to the Salvage Yard. Although quick, the Cobalt's engine is noisy and returns paltry fuel economy.