Measure the resistance between the D1 and B20 or Solenoid Valve Circuit B22 terminals. Remove the stiffener A , the steering gearbox 43. . Apply a light coat of new engine oil around the 5. Install and tighten the nut A on the front mount B , and install the ground cable C to the engine. Connect the alternator 4P connector terminal No. Terminal side of male terminals 2.
Check for continuity between the No. This entire book is f illed with important saf ety inf ormation please read it caref ully. Tighten it by hand, do not use a wrench. Attatch the front arm C to the front cylinder head with a spacer D and the 10 x 1. Place a rag or a shop towel over the hoses before disconnecting them. Sensor 2 Circuit High Voltage 10. Power is not transmitted to the countershaft.
Shift to P or N position. If you need to replace a part, use Honda parts with the — Use other protective wear when necessary, for correct part number or an equivalent part. Tighten the idler pulley bolt. Remove the drive plate A and washer B from the engine crankshaft 56. Remove the alternator-compressor belt see page 25.
Generally, the higher the speed the greater the risk, but serious injuries can also occur at lower speeds. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Remove the connecting rod caps after setting the 10. Hold the engine at 3,000 rpm with no load in Park or neutral until the radiator fan comes on, then let it idle. Replace the faulty ignition coil. T he inf ormation and specif ications included in this publication were in ef f ect at the time of approval f or printing. Disconnect the vacuum hose and fuel return hose from the fuel pressure regulator B.
Transmission Fluid Pressure Switch Circuit 4. Fasten and Position the Seat. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term. Connect a jumper wire between radiator fan switch 1. Warm up the engine to normal operating temperature the radiator fan comes on. Lubricate with new engine oil as shown.
If the measurements are out of the service limit, problems and probable causes are listed in the 2. . At idle, make sure there is a clicking sound from the ignition coil cover see page 9-4. Apply new engine oil to the piston pin snap rings A and turn them in the ring grooves until the end gaps are lined up with the cutouts in the piston pin bores B. It explains how your airbag work, and it tells you how to properly restrain inf ants and children in your vehicle.
However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Disconnect the radiator fan motor 2P connector. Take care not to bend the cables when removing them. Place the thrust washer A in the transmission following procedure. Remove radiator fan switch A from the water B 2P connector terminals No.
Install and tighten the nut A on the front mount. Set the control shaft A to the N position by turning new O-rings, new gasket, and harness clamp bracket B. Set the dial indicator A to the countershaft idler a puller B. Remove the harness clamp bolt and the two transmission range switch bolts, then remove the transmission range switch. Make sure that the intake primary rocker arm A bolts, then install and connect the special tools as and intake secondary rocker arm B are shown. Troubleshooting Information see page 14-3 before you troubleshoot. Connect alternator 4P connector terminal No.
Check the temperature reading on the scan tool. When discolored Mark 3 3. Therecommendationsonthispage are the ones we consider to be the most important. Overall width 1,920 mm 75. Measure the resistance between the D2 and B20 or Valve B Circuit B22 terminals. Remove the two end intake rocker shaft mounting 9. Warm up the engine to normal operating 8.