Seemed bothered that I called at all. To lengthen the belt, turn the tongue at a right angle to the belt and pull across your lap until it reaches the buckle. Roadside Emergencies 138 Page 139 3. Do not leave the vehicle unattended with the transfer case in N Neutral position. Pull the seat release lever located on top of the seatback while pushing the seatback down onto the seat cushion. Rotate the seatback downward into the load floor position. .
Never use pillows, books, or towels to boost a child. Driving 105 Page 106 Loaded vehicles, with a higher center of gravity, may handle differently than unloaded vehicles. Department of Transportation requires Ford to give you the following information about tire grades exactly as the government has written it. The BeltMinder feature is a supplemental warning to the seat belt warning function. To reset the moon roof positions, move the moon roof into the vent position. You can choose which slot will be loaded by pressing the desired preset number. Each number must be pressed within five seconds of each other.
Seating and Safety Restraints 69 Page 70 Reclining the seats Pull the lever located on the outside of the seat to recline the seatback. Whenever driving on a hill, determine beforehand the route you will use. Pull the lap belt portion across the child seat toward the buckle and pull up on the shoulder belt while pushing down with your knee on the child seat. If failure repeats, bring your vehicle to your dealer to have the new key s programmed. Fuel pump shut-off switch In the event of an accident the safety switch will automatically cut off the fuel supply to the engine.
Remove the two screws and lamp assembly from vehicle. Driving through deep water where the transmission vent tube is submerged may allow water into the transmission and cause internal transmission damage. It detects a rapid application of the brake pedal and maximizes the amount of brake booster assist, helping the driver to achieve maximum braking pressure. Buckle, then unbuckle, the safety belt three times, ending with the safety belt unbuckled. The BeltMinder feature is activated -the safety belt warning light illuminates and the warning chime sounds for 6 seconds every 30 seconds, repeating for approximately 5 minutes or until safety belt is buckled. Avoid excessive speed because vehicle momentum can work against your vehicle and cause it to become stuck.
Turn the heater fan on in both vehicles to protect any electrical surges. Only connect batteries with the same nominal voltage 12 volts. The purpose of these head restraints is to help limit head motion in the event of a rear collision. Very patient with my daughter needs. Press and release this control to decrease the vehicle set speed in small amounts by 1. Rear window defroster The rear defroster control is located on the instrument panel.
The current location number should be displayed. Do not start the engine when your vehicle is on the jack. Do not use the speed control in heavy traffic or on roads that are winding, slippery or unpaved. Do not start your vehicle in a closed garage or in other enclosed areas. Canadian customers who need to obtain reimbursement information, call 1 — 800 — 665 — 2006. This will take up to three circles to complete calibration. Autostore Autostore allows you to set the strongest local radio stations without losing your original manually set preset stations.
After three driving cycles without these or any other temporary malfunctions present, the light should turn off. To prevent the vehicle from moving when you change a tire, be sure the parking brake is set, then block in both directions the wheel that is diagonally opposite other side and end of the vehicle to the tire being changed. The decisions of the Board are binding on Ford and, in some cases, on the dealer but not on consumers who are free to pursue other remedies available to them under state or federal law. For Pioneer Edition vehicles, the 40 percent rear seat behind the driver does not fold due to the subwoofer location. Modulate the temperature control to maintain comfort. Do not hold for longer that 30 seconds.
Cold starting performance can also be improved by using an engine block heater. Seating and Safety Restraints 96 Page 97 3. Engine Engines are more efficient when they are clean because grease and dirt buildup keep the engine warmer than normal. The payload equals the gross vehicle weight rating minus base curb weight. Remove the jack and fully tighten the lug nuts in the order shown. Remove the bulb socket from the lamp assembly by turning counterclockwise.
Go to the front of the vehicle and release the auxiliary latch that is located under the front center of the hood. Remove the two screws and lamp assembly from vehicle. Safety belt extension assembly If the safety belt is too short when fully extended, there is a 20 cm 8 inch safety belt extension assembly that can be added part number 611C22. Whenever driving on a hill, determine beforehand the route you will use. Children and safety belts If the child is the proper size, restrain the child in a safety seat. The interior lamps will illuminate after pressing the first control on the keypad. Press the lower release control downward to unlatch the seatback.
BeltMinder reminds us to take a few seconds to buckle up. In the event of an emergency stop, do not attempt any sharp steering wheel movements. However, air temperature and fan speed are controlled by the main climate control system. Trailer lamps Make sure your trailer lamps conform to local and Federal regulations. Setting the lock for one door will not automatically set the lock for both doors. To replace any of the interior bulbs, see a dealer or qualified technician. InstalledOptionsFilter selectedInstalledOptionIdList, installedOptionIdToLabelMap, possiblyDroppedOptionsMap ; installedOptionsFilter.