Also, please go to Auto Zone or O'Reilly's and for free they can pull the codes to the car. Fuel pressure bleed past the check valve in the module. I also think you'll have to disconnect a harness plug with bolt in it on the drivers side. The block is made of cast iron and the heads are an aluminum alloy. The check valves are not serviced separately Also, the electric fuel pump is not serviced separately.
When you get those out, and the steering wheel is sitting in the seat or on the floor, the whole dash and panel should tilt and lay on the seats. Insert other end of Adaptor Tool Hose into a graduated container. Until 2002, Dodge hadn't installed a 4. The fuel injector rail, of the 4. In 2003, Dodge continued production of the third generation of the Ram 1500, a successful line of half-ton trucks that the company had first manufactured in 1994.
If both fuel pressure and capacity are low, replace fuel pump module. Safety features included front driver and passenger airbags, with side-curtain airbags as an upgrade. . A 12 volt , permanent magnet, electric motor powers the fuel pump. While there for free also they can bring their tester out and check your battery, alternator and starter. Most of the engine specifications and performance numbers are the same among all three generations, but Chrysler did make some modifications.
The final version of the 4. After the vehicle has cooled down, fuel pressure may drop to 0 psi cold fluid contracts , but liquid gasoline will remain in fuel supply line between the check valve and fuel injectors. Obtain correct Fuel Line Pressure Test Adapter Tool Hose. Install protective cap to fuel rail test port. Fuel pressure should be 339 kPa 34 kPa 49. All specifications, prices and equipment are subject to change without notice.
If engine runs, but pressure is below 44. The valve system uses a hydraulic end-pivot roller rockers system. In 2003, buyers were able to purchase the Ram 1500 with an extended or Quad cab four-door and a 6. Fuel pressure bleeding past the fuel injectors. It is also used to keep the fuel supply line full of gasoline when pump is not operational. If the electrical fuel pump, primary inlet filter, fuel filter or fuel pressure regulator require service, the fuel pump module must be replaced.
Refer to Fuel Pressure Release Procedure. Once they check your codes, if they find something and you don't get it fixed and need to get back with us, please make sure you tell us exactly what the code was, number and all. It is also used to keep the fuel supply line full of gasoline when pump is not operational. Connect the 0 - 414 kPa 0 - 60 psi fuel pressure test gauge from Gauge Set 5069 to the test port on the appropriate Adaptor Tool. Towing and hauling capacities depended on the bed length and drive configuration. Some engines may require air cleaner housing removal before line disconnection.
Different vehicles recorded varied performance numbers using the 4. Do not operate fuel pump for longer than 7 seconds with fuel line disconnected as fuel pump module reservoir may run empty. If pressure now holds at or above 30 psi , a fuel injector or the fuel rail is leaking. Refer to the Fuel Pressure Leak Down Test for more information. This V-8 Magnum, based on the 1998 Chrysler PowerTech platform, consisted of an iron block and aluminum alloy heads.
It produced 240 horsepower at 4,800 rpm and 300 foot-pounds of torque at 3,200 rpm. Fuel pressure bleeding past the check valve in the fuel pump module. Louis, Missouri; and Saltillo, Mexico. Connect correct Fuel Line Pressure Test Adapter Tool Hose between disconnected fuel line and fuel rail Fig. They had hydraulic control, with electronically controlled governor overdrive, overdrive lockout and converter clutch. On some engines, air cleaner housing removal may be necessary before fuel line disconnection.